If you’re wondering how much you can put in a box, you’re not alone. This can offer a difference in costs for a lot of business professionals. Boxes of course are made of layers of paper, with a liner inside, outside, and then fluting that’s between. The fluting offers layers and offers structure to the boxes to offer more protection. The corrugated or containerboard method does protect your products and offers the strength that’s needed for this weight as well. 

The strength does start with the material that’s in place, where the strength of the box does start with how dense it is. The larger your walls are or the more walls there are, the stronger it will be. Usually, you can check the inside of a box to see if they are single, double, or triple walled to figure out how strong this box is. 

Because not all of them are made the exact same way, the dimensions do vary, so the weight that can be offered does vary. Businesses can figure out the logistics of this and figure out whether or not this will effect the supply chain of management. However, the size of the box does not affect the total overall strength of the box. While it might be tempting to measure from your outer parts of the box, the box size is usually based on the inner parts of the dimensions, and while length is typically the first one mentioned, the longest is the opening part of this, which is then followed by the depth and the width. 

Ideally though, corrugated boxes go with a 2:1:2 ratio of this, but they can be a different dimension for different products that won’t fit the normal sizes. For boxes that fit all kinds of sizes, the proper calculation of this weight is usually done with the edge crush test, or ECT. This is a measure of the strength of the board and is made by compressing the smaller segments of board between two plates which are rigid, perpendicular to the way the flutes are, until you get the peak load decided.

Compared to the other standards, this ECT rating usually results in smaller materials, a lower energy requirement, and of course, a better usage f energy and to reduce the pollution that’s there. This also plays a part in the life cycle of packaging. The ECT test is usually calculated by looking at the number. 

The smallest will be 32, and that holds about 30 pounds. The largest is 82 and that holds up to 140 pounds. In general, you  can look at the different numbers in between, and from there, see what the best kinds of boxes are. There are those that go above 82 on the ECT, but the thing is, that’s usually a much higher cost. 

If you do plan to use this, you can make the correct decisions finally on the amount of product to have in the box, and how big the box should be for your needs too, and that’s something that can help you.If you’re not sure whether or not this type of box is right for you, then you’ll want to make sure that you figure out the best kind of packaging through asking someone. 

There are tons of ways to go about getting the right containers and boxes for your needs, and we are able to provide the basics so that you know the right kind of box that you need for those packaging needs, and what is right for you too.